*pleas note: we do not offer any support with setup, troubleshooting, upgrades on any of our hotspots. For instructions how to setup and troubleshoot your pistar based hotspot please refer to pistar website www.pistar.uk thank you.
Duplex MMDVM Hotspot Board + OLED + Antenna + Case Kit Support P25 DMR YSF For Raspberry Pi W ZERO
-High performance 32-bit ARM processor
-Supports DMR, P-25, D-Star and System Fusion
-Onboard LED to show status (TX, RX, PTT, Mode)
-SMA antenna connector, antenna included
-Mounts cleanly on all current Raspberry Pi's including the Pi Zero
WIDELY COMPATIBLE: Supports DMR, P-25, D-Star and System Fusion
WORK with RASBERRY Pi: Mounts cleanly on current Raspberry Pi including the Pi Zero
Mode:Support both Duplex mode and Simplex mode
Differencs in Duplex and Simplex:in Duplex mode,have 2 time slots, and Tx and Rx can do at the same time
Radio Frequency : in duplex mode,support uhf 430-440MHZ, in simplex mode support both uhf 430-440MHz and vhf 140-150MHz
Best adjusted: TX =0, RX=0，need no offset.
Modem select: STM32-DVM/MMDVM_HS-Raspberry pi Hat(GPIO)
Aluminum shell:High RF performace
Antenna:4 antenna, 2 for UHF, 2 for VHF
LEDs:on board leds to show status, with status words on shell
1. OLED display x1 (installed on board)
2. Raspberry Pi Zero W x1
3. Duplex MMDVM hotspot board x1
4. 8G TFT card x1
5. Aluminum Shell x1
6. 433Mhz Antenna x2.
7. 145Mhz Antenna x2
Fully assembled and tested
30 Days full replacement, 1 Year manufacture warranty, customer pays the shipping cost.