NanoVNA-H 50KHz-1500MHz Vector Network Analyzer Kit MF HF VHF UHF
HUGEN Original, yes Ham Radio Clubs you asked for the real deal here it is. HUGEN NanoVNA-H which covers from 50Khz-1.5Ghz! (1.5Ghz with extendable firmware )
NanoVNA is very tiny handheld Vector Network Analyzer (VNA),designed by edy555, it is a very portable but high-performance vector network analyzer. It is standalone with lcd display, portable device with battery. This is the updated version with Shielded RF components.
At first, NanoVNA was designed to work at 50kHz-300MHz. NanoVNA's mixer SA612A needs 5V power supply to work properly. The battery can't be driven directly. The original version of NanoVNA needs external USB power supply to work properly.Hugen recreated the NanoVNA based on the schematic of the edy555 and added a DC-DC circuit to allow the NanoVNA to work independently. Hugen tried to extend the measurement frequency using harmonics, allowing the NanoVNA to measure frequencies up to 900MHz. The Hugen version of the hardware and software is available through this link.
You can make or purchase a finished NanoVNA at a low cost. NanoVNA is now the most active vector network analyzer and antenna analyzer project in the community. Usually buying a finished NanoVNA-His the most convenient way to get NanoVNA.
Edy555 is updating his software, harmonic extensions have been added, usually a well-made NanoVNA can be acquired better than 40dB dynamics at 900MHz , even we can expand to 1.5GHz, but only 20dB dynamics above 900MHz.
Cho45 adds TDR (Time Domain Reflectometer) functionality to the NanoVNA. Time domain measurements are widely required by the community to quickly measure the length of the coaxial cable and determine the cable fault point by calculating the discontinuous impedance.
Color: black plastic case
Measurement frequency: 50KHz~300MHz (50KHz~900MHz, enable extended firmware)(the products will be updated with the latest firmware before shipping, the actual measurement frequency is 50KHz~900MHz)
RF output: -13dbm (maximum -9dbm)
Frequency accuracy: <0.5ppm
Measurement range: 70dB (50KHz-300MHz), (50dB (300M-600MHz), 40dB (600M-900MHz) enable extended firmware)
Port SWR: <1.1
Display: 2.8 inch TFT (320*240)
USB interface: USB type-C
Communication mode: CDC (serial)
USB: 5V 120mA
Battery: 3.7v battery
Number of calibration points: 101 (fixed)
Number of scanning points: 101 (fixed)
Display tracking: 4, Marking: 4, Setting save: 5
PCB size: 85.5 * 54 * 11mm / 3.4 * 2.1 * 0.4in (without connectors and switches)
Package weight: 245g
* This is the original HUGEN Brand nanovna unit, this is not a clone of any kind.