OSTAR Jumbospot MMDVM Hotspot for Brandmeister DMR, YSF, D-STAR

*pleas note: we do not offer any support with setup, troubleshooting, upgrades on any of our hotspots. For instructions how to setup and troubleshoot your OSTAR based hotspot please refer to the website below https://www.mmdvm.club/index.php/ostar.html thank you.

OSTAR - Experimental Jumbospot based on flashed eprom vs SDCARD. This is for users with advanced computer skills.

Supports DMR (Brandmeister), D-Star , System Fusion (FCS, YSFReflector), P25 , NXDN ,Pocsage networks.
UHF + VHF Dual Band
Very easy to use, works without a computer. No additional hardware required,  
Web interface for configuration and monitoring.
USB powered, low energy consumption, 10mW RF output.
Runs fully embedded software , running on an openwrt operating system. No TF card, bulky Windows software or failing SD cards!
Any Problem Just Press WPS key to factory reset

OSTAR Jumbospot is very similar to pistar hotspot. Runs very similar but much simple softwave OSTAR which is based on linux pistar. No more SDCARDS! The software is alredy flashed into ROM chip for you to use, just connect to dashboard and setup your information, your home router wifi and you are set to go! 

OSTAR host files are configured from factory to operate on YSF, DSTAR and DMR but Brandmeister network only. If you want this hotspot to connect outside BRM network you need to edit configuraiton files which require SSH access and  linux skills.

OSTAR doesn't require any offsets either! no more hunting for any offsets, OSTAR works with all digital radios.

Duplex OSTAR mmdvm board:

WIDELY COMPATIBLE: Supports DMR, P-25, D-Star and System Fusion

Mode: Support both Duplex mode and Simplex mode

Differencs in Duplex and Simplex:in Duplex mode,have 2 time slots, and Tx and Rx can do at the same time

Radio Frequency : in duplex mode,support uhf 430-440MHZ, in simplex mode support both uhf 430-440MHz and vhf 140-150MHz

Best adjusted: TX =0, RX=0，need no offset.