QRM Eliminator X-Phase (1-30 MHz) HF bands, SO-239 connectors included

$130.00
(1 review) Write a Review
Shipping:
$15.00 (Fixed Shipping Cost)
Adding to cart… The item has been added

QRM Eliminator X-Phase (1-30 MHz) HF bands SO-239 connectors included

QRM Eliminator is a simple signal phasing device that can effectively reduce or remove noise interference for dramatically improved HF reception.

Product description

The QRM Eliminator is based on a totally innovative concept and cannot be compared to the performance of noise blanker or DSP circuits. Removing the noise before it gets to the receiver is the superior method of interference reduction

About this item

The QRM Eliminator is inserted into the feedline from the trx to the antenna without any additional modifications required to the radio. The box has a built-in PTT control which enables the Eliminator to stay connected during transmit. An additional auxiliary receiving antenna is required, though, like a 2m antenna or simply a couple of meters wire in the shack. The unwanted signal is received with both antennas resulting in different phases. The QRM Eliminator now allows to adjust the phase angle as well as amplification in a way to cancel out the unwanted signal before it reaches the receiver front end! It's based on a totally innovative concept and cannot be compared to the normal 'noise blanker' performance.

 

  • Principle: The QRM canceller is inserted from the into the antenna's feeder without any additional modifications to the radio. The box has a built-in PTT control that keeps the canceller connected during transmission.
  • However, an additional auxiliary receiving antenna is required, such as a 2m antenna or a few meters of wire in a shed. The two antennas received unwanted signals, resulting in different phases.
  • The QRM canceller now allows adjustment of the phase angle and amplification to cancel unwanted signals before they reach the receiver front end! It is based on a completely innovative concept and cannot be compared with normal "silencer" performance.

X-Phase is located in a shack in the vicinity of your TRX and is included in the gap of the antenna feeder. In case you are using PA, between TRX and PA. Thus, the "Main" jack must be connected main operating antenna or PA input. Connect the "TRX" jack to the antenna socket of the transceiver. To the "AUX" jack, connect the AUX antenna, 2 to 5 meters Any wire stretched along the shelf of your shack. The Qrm Eliminator contains interface circuitry necessary for operation with most modern HF transceivers.

 

As can be seen from the circuit diagram, the X-Phase device in transmission mode forms through high-frequency channel between the connectors "TRX" and "MAIN". Maximum The power of the high-frequency signal transmitted through this channel should not be exceed 100 watts! Do not connect the instrument to the PA output under any circumstances!

 

Package list:

a. Host: 1 set;
b. PTT: 1 line;
c. SMA head rod antenna: 1;
d. Dc2.1 / 5.5 power cord: 1

 

* all units are assambled and tested before shipping.

 

30 Days full replacement, 1 Year manufacture warranty, customer pays the shipping cost.

1 Review Hide Reviews Show Reviews

  • 5
    Does an excellent job

    Posted by Michael Vink on 2021 Oct 19th

    Takes some getting used to but attached to a log (listen) and a Terminated End Fed Vee (TX) antenna works wonderfully