QRM Eliminator X-Phase Version II (1-30 MHz) HF bands SO-239 connectors included
QRM Eliminator is a simple signal phasing device that can effectively reduce or remove noise interference for dramatically improved HF reception.
Product description
The QRM Eliminator is based on a totally innovative concept and cannot be compared to the performance of noise blanker or DSP circuits. Removing the noise before it gets to the receiver is the superior method of interference reduction
About this item
The QRM Eliminator is inserted into the feedline from the trx to the antenna without any additional modifications required to the radio. The box has a built-in PTT control which enables the Eliminator to stay connected during transmit. An additional auxiliary receiving antenna is required, though, like a 2m antenna or simply a couple of meters wire in the shack. The unwanted signal is received with both antennas resulting in different phases. The QRM Eliminator now allows to adjust the phase angle as well as amplification in a way to cancel out the unwanted signal before it reaches the receiver front end! It's based on a totally innovative concept and cannot be compared to the normal 'noise blanker' performance.
- Principle: The QRM canceller is inserted from the into the antenna's feeder without any additional modifications to the radio. The box has a built-in PTT control that keeps the canceller connected during transmission.
- However, an additional auxiliary receiving antenna is required, such as a 2m antenna or a few meters of wire in a shed. The two antennas received unwanted signals, resulting in different phases.
- The QRM canceller now allows adjustment of the phase angle and amplification to cancel unwanted signals before they reach the receiver front end! It is based on a completely innovative concept and cannot be compared with normal "silencer" performance.
X-Phase is located in a shack in the vicinity of your TRX and is included in the gap of the antenna feeder. In case you are using PA, between TRX and PA. Thus, the "Main" jack must be connected main operating antenna or PA input. Connect the "TRX" jack to the antenna socket of the transceiver. To the "AUX" jack, connect the AUX antenna, 2 to 5 meters Any wire stretched along the shelf of your shack. The Qrm Eliminator contains interface circuitry necessary for operation with most modern HF transceivers.
As can be seen from the circuit diagram, the X-Phase device in transmission mode forms through high-frequency channel between the connectors "TRX" and "MAIN". Maximum The power of the high-frequency signal transmitted through this channel should not be exceed 100 watts! Do not connect the instrument to the PA output under any circumstances!
​Package list:
* all units are assambled and tested before shipping.
4 Reviews Hide Reviews Show Reviews
-
Qrm eliminator
It works! But don't expect perfection, it's all about signal to noise ratio.
-
QRM Eliminator X-Phase
I have always had S-9 on 40 & 80 meters, well not anymore, this unit removes all QRM and lets me see all the stations on my Icom 7300 scope, awesome unit, A+
-
QRM Eliminator X-Phase
I have always had S-9 on 40 & 80
-
Does an excellent job
Takes some getting used to but attached to a log (listen) and a Terminated End Fed Vee (TX) antenna works wonderfully
